eGrip kit original Joyetech.
eGrip is the first built-in atomizer e-cigarette from Joyetech. It features not only a transparent liquid window but also a 360-degree regulation ring to adjust output wattage(8W-20W).
Moreover, air flow can be customized with the special tool to suit your vaping habits. The eGrip also utilizes its dedicated atomizer head, the eGrip CS head (1.5 Ω resistance) which complements its high output.
Standard Configuration:
-
1× eGrip Mouthpiece
-
1× eGrip Body
-
2× eGrip CS Atomizer Head
-
1× eGrip Atomizer Base
-
1× 1A Wall Adaptor
-
1× USB Cable
-
1× Manual & Warranty Card
Specification:
-
Size: 46.4mm x 20.4mm x 99.5mm (including mouthpiece);
-
Capacity: 1500mAh
-
Output mode: VW Mode
-
E-juice Capacity: 3.6ml
-
eGrip CS Atomizer Head: 1.5Ω resistance
VW mode (8W-20W): In this mode, wattage output can be adjusted by rotating the regulation ring clockwise or counterclockwise. With the wattage increasing, the vapor speed will be faster and you can enjoy a huger vapor.
Regulation of air inlet: Spin the adjustable screw on the side of the bottom. Contrarotate the screw will loosen the screw. The looser the screw is, the bigger the air inlet is.
Liquid filling: Push up the lid on the side of eGrip body, then slowly refill the liquids into the hole. And do remember to lock the cap after finishing filling.
Atomizer Head replacement: Unscrew the big screw at the bottom with a coin, and the atomizer head is located on the base of it. Simply unscrew the atomizer head and replace a new one.(Please do remember to screw up the atomizer head before use.)
Charging: Plug the USB cable to the eGrip body from the bottom, and connect it to the wall adaptor or other power source such as a computer. (it can be used whilst on charge). When connected with USB charger, the button light will falsh 5 times and continue to flash slowly while charging. The button light will go out when the device is fully charged.
There are currently no product reviews.
Write Review