Innokin iTaste 134 Stainless steel original mod with Variable Wattage
The iTaste 134 is a microprocessor-controlled VW mod that allows you easily adjust the wattage with a rotational wheel . The solid stainless steel body gives it a fairly hefty weight. With 510/eGo threading, and a removable beauty ring, this mod is compatible with virtually any clearomizer, cartomizer or tank. It is a great device for all vapers !
The iTaste 134 uses a single 18650 battery (not included). The battery capacity is displayed on the switch via green, yellow, and red LED lights.
-
Green = fully charged
-
Yellow = half discharged
-
Red = Charge Needed
Available color : Stainless steel
The kit includes the following :
-
Innokin iTaste 134 Stainless steel original mod with Variable Wattage
-
Innokin iClear 30 Dual Coil Clearomizer
Main Features:
-
Scale Display Wattage: Scale display wattage improves intuitive control and provides more accurate performance…
-
Variable Wattage: The rotational wheel adjusts wattage in the following increments: 7.0 , 8.0 , 8.5 , 9.0 , 9.5 , 10.5 , 11.0 , 12.0 , 12.5 .
-
Use lower wattage for low-resistance (ohms) accessories and higher wattage for high-resistance (ohms) accessories
-
Battery Level Indicator: The iTaste 134 battery capacity is displayed via green, yellow, and red LED lights. Green = Fully Charged Yellow = Half Discharged Red = Charge Needed
-
High compatibility 510 connector: Will fit iClear16, and iClear30 dual coil clearomizers, as well as standard 510 accessories
-
ON/OFF Battery Switch: Quickly clicking the power button three times will enable or disable the battery. Once enabled, holding down the button will activate the device. This safety feature prevents the atomizer from turning on while it's in your pocket or bag and prevents accidental changes to your settings.
-
10-Seconds Cutoff: If the button is held down for 10 seconds or longer, the iTaste 134 will shut itself off until the button is released and pressed again
-
Short Circuit Protection
-
Reverse Battery Protection Circuit
-
Low voltage warning
Other specifications :
-
The standby current: 150uA maximum
-
Maximum output voltage: 6.0V (unloaded)
-
Maximum output current: 5.0A(Built in 7A fuse for protection and stability.)
-
Maximum output wattage: 12.5W(Watts mode)
-
Resistance of clearomizer: 1.2 ohm (minimum)
-
Battery: Fits 18650 batteries
There are currently no product reviews.
Write Review